| Features | |
|---|---|
| Hourly operation efficiency | 15 acres |
| High-precision radar | √ Spherical Omnidirectional Radar System |
| Remote control planning precision | √ (RTK/GNSS) |
| Removing air from pipes | √ One button Air Discharge |
| 3D operation planning of the AI engine | √ |
| High-precision flowmeter | √ (Dual-channel electromagnetic flowmeter with an error of ±2%) |
| Level gauge | Single-point level gauge |
| Maximum spray flow | 1.8 L/min (with standard XR11001VS nozzle) 2.4 L/min (with optional XR110015VS nozzle) |
| Pesticide tank installation method | Quick plugging pesticide tank |
| Battery installation method | Quick plug-and-play battery |
| One remote control for multiple drones | √ (one remote control for three drones) |
| D-RTK technology | √ |
| Up-looking radar module | √ |
| Flight dotting function | √ |
| Smart cruising/return function | √ |
| Intelligent supply-point prediction | x |
| Coordinated turn function | √ |
| Forward-looking FPV | √ |
| Backward-looking FPV | √ |
| Branch targeting technology | x |
| Drone parameters | |
| Total weight (without batteries) | 13 kg |
| Rated take-off weight | 24.8 kg (near sea level) |
| Hovering precision (with good GNSS signal) | With D-RTK enabled: ±10 cm (horizontal) and ±10 cm (vertical) With D-RTK disabled: ±0.6m (horizontal) and ±0.3m (vertical) (with the radar function enabled: ±0.1 m) |
| RTK/GNSS frequency bands | RTK: GPS L1/L2, GLONASS F1/F2, BeiDou B1/B2, and Galileo E1/E5 GNSS: GPS L1, GLONASS F1, and Galileo E1 |
| Maximum power consumption | 3,700 W |
| Hovering power consumption | 3,200 W |
| Hovering time | 17 min (@9,500 mAh & takeoff weight of 16 kg) 9 min (@9,500 mAh & takeoff weight of 24.8 kg) |
| Maximum pitch angle | 15 Deg. |
| Maximum operating flight speed | 7 m/s |
| Maximum level flight speed | 10 m/s (with good GNSS signals) |
| Maximum endurable wind speed | 8 m/s |
| Max Take-off Altitude | 4,500m *Reduce the pesticide amount by 12% with each increase of 1,000 meters of altitude. |
| Recommended operating ambient humidity | < 93% |
| Recommended operating ambient temperature | 0 Deg.C to 45 Deg.C |
| Rack parameters | |
| Maximum rotor distance | 1,480 mm |
| Dimensions | 1,958 mm x 1,833 mm x 553 mm (with arms and blades extended) 1,232 mm x 1,112 mm x 553 mm (with arms extended and blades folded) 600 mm x 665 mm x 580 mm (with arms folded) |
| Power system - Motor | |
| Stator size | 100 x 10 mm |
| KV value | 84 rpm/V |
| Maximum pulling force | 11.2 kg/rotor |
| Maximum power | 2,500 W/rotor |
| Weight | 527 g |
| Power system - Propellers | |
| Diameter × pitch | 33 x 9 inch |
| Weight (a single blade) | 92 g |
| Power system - ESC | |
| Maximum operating current (continuous) | 32 A |
| Maximum operating voltage | 60.9 V (14S LiPo) |
| FPV Camera | |
| FOV | Horizontal: 129 Deg., vertical:82 Deg. |
| Resolution | 1,280 x 720 15-30 fps |
| FPV spotlight | |
| Maximum light intensity | 13.2 lux @ 5-meter direct light |
| Spraying system - Operation tank | |
| Operation tank volume | 8 L at full load |
| Operating load | 8 kg at full load |
| Spraying system - Nozzles | |
| Sprayer model | XR11001VS (standard) XR110015VS (optional) XR11002VS (optional) |
| Number of sprayers | 4 |
| Maximum spray flow | XR11001VS: 1.8 L/min XR110015VS: 2.4 L/min XR11002VS:3 L/min |
| Diameter of atomized particle | XR11001VS : 130 - 250 μm XR110015VS : 170 - 265 μm XR11002VS: 190 - 300 μm (depending on the actual operating environment, spraying flow and other factors) |
| Maximum effective spray width | 3 - 5.5m (with 4 sprayers and a distance of 1.5 - 3 meters to crops) |
| Spraying system - Water pump | |
| Water pump model | Diaphragm pump |
| Operating voltage | 15 V |
| Maximum flow | 1.5 L/min x 1 |
| Spraying system - Flowmeter | |
| Flow measurement range | 0.25 - 20 L/min |
| Flow measurement error | < ±2% |
| Measurable liquid | Conductivity > 50 μS/cm. Typical liquid: Tap water, aqueous organic or inorganic pesticides, and the like |
| Omnidirectional obstacle avoidance radar | |
| Model | RD2424R |
| Operating frequency | SRRC/NCC/FCC: 24.05 to 24.25 GHz MIC/KCC/CE: 24.05 to 24.25 GHz |
| Operating power consumption | 12 W |
| Equivalent isotropic radiated power (EIRP) | SRRC: < 13 dBm; NCC/MIC/KCC/CE/ FCC:< 20 dBm |
| Height hold and terrain following | Height measurement range: 1 - 30m Height hold range: 1.5 - 15m Maximum slope in mountain mode:35 Deg. |
| Obstacle avoidance system | Perceivable distance: 1.5 - 30m FOV: 360 Deg. (horizontal), ±15 Deg. (vertical) Conditions of use: The relative flight height of the drone is above 1.5m and the speed below 7 m/s Safe distance: 2.5m (the distance between the tip of the blade and the obstacle after the drone is braked and hovering stably) Obstacle avoidance direction: Horizontally omnidirectional obstacle avoidance |
| Protection class | IP67 |
| Up-looking radar | |
| Model | RD2414U |
| Operating frequency | SRRC/NCC/FCC: 24.05 to 24.25 GHz MIC/KCC/CE:24.05 to 24.25 GHz |
| Overhead obstacle avoidance | Perceivable distance: 1.5 - 10m FOV: 80 Deg. Conditions of use: The drone flies for a relative distance over 1.5 m in the mode of take-off, landing and route climb mode Safe distance: 2m (the distance between the obstacle and the highest point on the top of the drone) Obstacle avoidance direction: Above the drone |
| Protection class | IP67 |
| Equivalent isotropic radiated power (EIRP) | SRRC:< 13 dBm;NCC/MIC/KCC/CE/ FCC:< 20 dBm |
| Operating power consumption | 4 W |
| Battery | |
| Model | BAX501-9500mAh-51.8V |
| Weight | About 3.8 kg |
| Discharge rate | 11.5C |
| Protection class | IP54 + board-level embedment protection |
| Capacity | 9,500 mAh |
| Voltage | 51.8 V |
| Remote control | |
| Model | RM500-ENT |
| Operating frequency of OcuSync 2.0 | 2.4000 to 2.4835 GHz 5.725 to 5.850 GHz |
| Effective signal distance of OcuSync 2.0 (without interference and blockage) | SRRC: 5 km; MIC/KCC/CE: 4 km; FCC: 7 km (measured at the operating height of 2.5m) |
| EIRP of OcuSync 2.0 | 2.4 GHz SRRC/CE/MIC/KCC: 18.5 dBm; FCC: 29.5 dBm; 5.8 GHz SRRC: 28.5 dBm; FCC: 20.5 dBm CE:12.5 dBm |
| Wi-Fi Protocols | Wi-Fi Direct, Wireless Display, and 802.11a/g/n/ac. 2 x 2 MIMO Wi-Fi is supported |
| Wi-Fi operating frequency | 2.4000 to 2.4835 GHz 5.150 to 5.250 GHz 5.725 ~ 5.850 GHz |
| Wi-Fi EIRP | 2.4 GHz SRRC/CE: 18.5 dBm; FCC/MIC/KCC: 20.5 dBm; 5.2 GHz SRRC/FCC/CE/MIC: 14 dBm; KCC: 10 dBm; 5.8 GHz SRRC/FCC: 18 dBm; CE/KCC: 12 dBm; |
| Bluetooth protocol | Bluetooth 4.2 |
| Bluetooth operating frequency | 2.4000 to 2.4835 GHz |
| Bluetooth EIRP | SRRC/MIC/FCC/CE/KCC:6.5 dBm |
| Positioning | GPS + GLONASS |
| Display | 5.5-inch screen with a resolution of 1,920 x 1,080 and brightness of 1,000 cd/m², and Android OS |
| Operating memory (RAM) | 4GB LPDDR4 |
| Storage space (ROM) | 32 GB + scalable storage space, and a microSD card with the capacity up to 128 GB and transfer speed of UHS-I Speed Grade 3 is supported |
| HDMI | HDMI 1.4 |
| Supported drones | T30 and T10 crop protection drones |
| Operating power consumption | 18 W |
| Operating ambient temperature | -10 Deg.C to 40 Deg.C |
| Storage ambient temperature | -30 Deg.C to 60 Deg.C (within 1 month) -30 Deg.C to 45 Deg.C (1 to 3 months) -30 Deg.C to 35 Deg.C (3 to 6 months) -30 Deg.C to 25 Deg.C (more than 6 months) (with the capacity of built-in batteries at 40 to 60%) |
| Charging ambient temperature | 5 Deg.C to 40 Deg.C |
| Built-in battery of remote control | |
| Built-in battery | 18650 lithium ion battery (5,000 mAh at 7.2V) |
| Battery life | 2 hours |
| Charging method | Standard 12V/2A USB quick charger |
| Charging time | 2.5 hours (with the standard 12V/2A USB quick charger and the remote control powered off) |
| Power supply current/voltage of remote control USB-A port | 5 V / 1.5 A |
| External smart battery of remote control | |
| Model | WB37-4,920mAh-7.6V |
| Battery type | 2S LiPo |
| Capacity | 37.39 Wh |
| Voltage | 7.6 V |
| Charging ambient temperature | 5 Deg.C to 40 Deg.C |
| Battery life | 2 hours |
| External smart battery charging manager of remote control | |
| Model | WCH2 |
| Input voltage | 17.3 - 26.2 V |
| Output voltage and current | 8.7V and 6A |
| Operating ambient temperature | 5 Deg.C to 40 Deg.C |
| Power adapter of external smart battery charging manager | |
| Model | A14-057N1A |
| Input voltage | 100 to 240V and 50/60 Hz |
| Output voltage | 17.4 V |
| Rated power | 57 W |
| T-Series Spreading System 3.0 (8kg) | |
| Weight of distribution system | 3.1kg |
| Maximum opening area | 44.6 cm² |
| Applicable materials | Dry solid particles with a diameter of 0.5 to 5 mm |
| Volume of distribution tank | 12L |
| Maximum internal load of distribution tank | 10kg |
| Protection class | IP67 |
| Input voltage | Power: 60V Control:15V |
| Maximum power | 60V@250W 15V@50W |
| Recommended operating ambient temperature | 0 Deg.C to 40 Deg.C |
| Dimensions | 405 x 245 x 375mm |
| Maximum rotation speed | 1,300 RPM |
| T10 smart charging manager | |
| Dimensions | 300 x 280 x 230 mm |
| Total weight | 8.1 kg |
| Input voltage | 100-264 Vac |
| Output voltage | 40-60 V |
| Rated power | 3,600 W |
| Charging current | 50 A |
| Charging time | 7 to 10 min |
| Charging voltage precision | +/-0.1 V |
| Charging current precision | +/-1 A |
| Number of output channels | 2 |
| Protection functions | Over-temperature, over-voltage, under-voltage, short-circuit, and fan stall protection |
| Charging ambient temperature | -20 Deg.C to 45 Deg.C |
| Charging safety | AC wire protection, power wire protection, and charge connector protection |
|
Data source |
https://www.dji.com/t10/specs |
Generated using dronespec.info
Source data acquired 2023-01-23 19:03:44